How To Create Your Signal Jammer
How To Create Your Signal Jammer
This signal jammer uses 800MHz frequency to operate because many cell phones are working on the same frequency. So I chose the sweeping oscillator as my VCO. It is really efficient yet may be difficult to use if you are beginner without some semi-professional RF-testing tools.
The clock oscillator (45MHz) is driving a local oscillator port as my noise source and is located on the mixer of the mini circuit. To equate the impedance of a clock oscillator with the mixer there is an impedance matching network. Local oscillator signal goes through this network and impedance is matched.
The 800MHz antenna from the old cell phone is connected to the RF input (mixer port). The RF output then goes to the amplifier located on the mini circuit. The amplifier will increase produced output by 15-16dbm of pure power. The empowered signal is going to another old phone antenna.
GSM800 cell phones have their frequencies separated by 45MHz exactly. So when any cell phone tries to make a call - it becomes blocked by itself! The phone talker will hear its own voice.
You can also keep in mind that this cell phone signal jammer can block all cell-based trackers which use your car GPS to track you down and record the data. Even IEDs are probably could be jammed, at least those ones controlled by cell signals.
Tell others about
this page:
Comments? Questions? Email Here