Your Guide to Easy Drywall Installation
Drywall is vastly used in architecture, construction and renovation in Calgary. Tagged as gypsum board, wallboard or sheetrock, drywall overwhelmingly betters the foundation of interior walls and ceilings in residential or commercial buildings. Calgary drywall contractors claim drywall is a much more effective material than traditional wet plasters and wood forms. Installing drywall is a great way to improve the value of your home and conceal minimal flaws such as dents or cracks. Commercial drywall installation offers the same benefits.
Almost all drywall contractors can attest to the easiness of drywall installation and with constant practice, one can achieve professional results. Whether one opts to do the task himself or hire drywall contractors in Calgary, preparation is always the key to a successful project.
Preparation
Use the proper equipment or tools to avoid delay and a half-baked output. You’ll find various drywall tools and equipment in a home improvement center, drywall store or your local tool and equipment rental store. Learn how to operate these pieces of equipment properly to prevent accidents and to ensure the best result. Before getting down to drywall installation, the following tools should be present in your toolbox: T-square utility knife sanding block pencil tape measure chalk line saw drill or drywall screw gun
Drywall varies in size and thickness—quarter inch, three eights of an inch, half inch, and five eights of an inch. A thinner drywall is lightweight and easier to install while the thicker one is stiffer. Most prefer to use the standard size of drywall which is 3/8 and 5/8 inches thick, while the standard panel range is 4 x 8 feet. It is advisable to check the local building code to ensure that the drywall you’ll be using meets the criteria. This will help you avoid possible penalties.
Installation
Analyze the framework of your house before starting a drywall project. Professionals reveal that the secret to a lasting drywall is proper inspection of the wall’s framing before performing the installation. Make sure that there’s at least one inch exposed framing at corners and mark the location framing before you cover them with drywall. Also mark the location of ceiling joists on the top plate of the wall framing, so you’ll know where to put the screws after it’s covered with drywall.
When installing sheetrock, start in the corner of the room and work through the panel perpendicular to the ceiling joist. Before attaching the panel, make sure it is straight and that there is enough space for proper fastening. Fasten together the panel you’ve worked on and the one behind it for these two panels will share the same ceiling joist-from end to end or what is called a butt joint. Do not install panels horizontally, instead install them vertically. Also, avoid jamming or forcing drywall into a tight spot, cut the panel so it will fit inside the hole.
Avoid lining up a sheet of drywall at the edge of a door or window opening. The joint in these locations are weaker than solid drywall, even if it’s well taped. For interior walls, simply continue over the opening with a full sheet and cut out the opening after you have fastened the sheet. Windows on exterior walls are a little trickier. Measure and mark the sheet before hanging it. Get help for hanging notched sheets because the skinny section above the opening is often fragile.
About the Author
For more information check this site, Calgary drywall contractors.
Badeth Abonita is a web copywriter in accompany offering, residential drywall contractors
Tell others about
this page:
Comments? Questions? Email Here