Eight Easy Guidelines to Making Your Own Paper Shredder

Making your own paper shredder starts by assembling all the required tools and materials, preparing the blades, mixing the glue, preparing the scissors, putting glue to the scissors, affixing the remaining pairs of scissors, taping the handles all together, and finally, utilizing your new home-made paper shredder.

Paper shredders have become an essential tool for correct disposal of objects that have private information. Nonetheless, these devices or paper shredding services can cost a good amount of money. Good thing, though, an improvised paper shredder can easily be made at home with only a few tools and materials. Read this article to find out the steps to assembling your own paper shredder.

Gather all the needed tools and supplies

Have all the needed tools and supplies for this project in your work area. These include the following: welding glue, disposable receptacle to mix glue in, 4 similar pairs of scissors, and durable tape.

Prepare the blades

Buy four pairs of scissors that have long blades and which have short width at the scissors' section where the 2 separate parts are affixed by a screw. There should be less space in between the two pairs of scissors' blades when they are lined up with their screws one after the other. It is important that you get scissors with the label and the design that are all the same, so that all their shapes would line up evenly. Additionally, the rotating screws must have enough extension so that when glue is placed on them, none of the glue will get on the inside part of the scissors. Scissors that are made entirely of metal are preferred for this paper shredding device.

Mix the glue

Read the instructions for the mixture of the welding glue and follow it.

Prepare the scissors

Properly close the scissors; all four pairs of them.

Put on glue to the scissors

Have the pairs of scissors aligned top to bottom. Put a tiny amount of the glue, about the same size as a cotton bud tip, on top of the pivot screw of the first pair of scissors. Next, get the 2nd pair of scissors and have its pivot screw affixed to the adhesive on the pivot screw of the 1st pair of scissors. Be careful not to allow any of the glue material to get in the area between the two blades. Keep the scissors glued together and keep their parallel arrangements by holding them until the glue has set. The parallel position will allow for the creation of identical cuts on the objects to be shredded. Allow for the glue to totally dry before moving on to the next procedures.

Affix the remaining pair of scissors

Put on the same amount of glue as the former step on the pivot screw of the 3rd pair of scissors. After which, attach this pair of scissors to the first and 2nd pair in the same procedure. Next, continue on with the last pair of scissors in the same method. Glue only one pair of scissors each and every time and let the glue dry thoroughly before you work on another.

Secure the handles of the scissors

Get the tape and have long sections of it pass through all the scissors' handles. Tightly wrap the tape around the handles of the 4 pairs of scissors; so they will be connected together and maneuver all together as one.

Utilize your new home-made paper shredder

Get a sheet of paper and try shredding it to sections with your improvised paper shredder. Insert your thumb and your first couple of fingers through the handles of the 4 pairs of scissors. Next, cut the sheet of paper to shreds.

Since sharp objects are required for this project, always take proper safety measures. This device should also be kept away from children at all times.

Comments? Questions? Email Here

© HowtoAdvice.com

How to Advice .com