How to Check For a Faulty Breaker
The circuit breaker is the safety device responsible for cutting power inside a house or building when too much current flows through wiring. Usually this is inside the breaker box and it is important that homeowners and business maintenance personnel know where the breaker box is. Living in Texas, it is important that you have the number of an electrical service company handy for emergencies, as professionals should be the ones to inspect electrical matters. Make sure you know a company offering breaker box service in Dallas who could make regular inspections for your home or business.
Before you call an electric service, Heath, TX, you could do a routine check if breakers keep tripping by doing the following:
Check Circuit Breaker
If you do not have electricity in one or all areas of your house, it is time to check the circuit breakers inside the breaker panel box. Make sure the breakers are not tripped. One or more switch in the OFF position could be tripped because of an overload, and turning it back to the ON position could solve the problem. If the tripping continues, search for a company that offers breaker tripping inspection in Dallas, TX.
Check for Short Circuits
Turn the breaker OFF completely and then turn it on again. When it does not stay on or you hear a hum sound, repeat the action, and pull the wire out of the circuit breaker. In this case, the wiring might be faulty and you definitely need to call breaker box service Dallas.
Test the Panel
With the wire removed from the breaker, use the Voltmeter and test the active beaker. If there is voltage present, it means the breaker is fine, but that the breaker panel is faulty. In this case, you need to replace your breaker panel, but when there is no voltage, it could be the breaker itself. Only an electrical service Heath, TX, or specialist to replace breaker box, Heath, Dallas would be able to see what the problem is.
Change the Wire
Another method to test the breaker before calling breaker box service, Dallas is to move the breakers wire to another breaker in testing if it works. It is the most effective and simplest test. When moving the wire, remember that the breakers should be off. When trying the wire to another breaker box, turn it on and if the new breaker has a problem, it could be faulty wiring. When you have faulty wiring, you have to call specialist technicians at Art Electrical & HVAC Inc.
Use an Ohm-meter
Chances are that you or someone you know owns an Ohm-meter and you can do a final test to check the breaker. The breaker must be turned off first, then remove it, turned back on. Now use the ohm-meter and check between the bus clip and its screw. When the reading is above 5 ohms, the breaker is faulty and means technicians will replace breaker box, Heath, Dallas.
Specific instances where homeowners need professionals are definitely, when it comes to safety when working with electrical appliances, electrical service, heating installations, etc. Living in Texas and you need meter base replacement TX, breaker box service, Dallas, and more do not hesitate to give the experts a call today.
Art Electric & HVAC Inc. http://www.artsairconditioningrepair.com/electrical.php
About the Author
For more invo visit : http://www.artsairconditioningrepair.com/electrical.php
Tell others about
this page:
Comments? Questions? Email Here