Eight Quick Steps for Fixing a Pierced Pressure Washer Tire

Steps for repairing a punctured pressure washer tire starts with preparing the required tools, then transferring the pressure washer to a good location, after which is taking off the offending item, followed by preparing the puncture for the plug, next is inserting needle into the puncture hole of the tire, then placing the plug into the tire, and finally by inflating the tire of the power washer system.

As with every tire that is full of air, the tires of a power washer device are also prone to being pierced, especially when you wheel it all over your yard or other related area. You can always carry your pressure washer system to a tire shop; however, you can also quickly repair the problem in your house. You simply need to learn a couple of simple elements to do it.

Prepare the necessary tools

Get all the necessary devices and things for fixing the tire of your portable pressure washers ready. These involve the following: a pair of pliers, a tire plug package, and an air pump motor.

Transport the power washer to a great area

Find the best location where you can fix the tire of the power washer and transport the machine to this place. This specific place must have good lighting and be well-leveled. Take a good close look at the tire because the hole inside it may be very tiny.

Take off the offending item

With the use of the pair of pliers, keep the offending object which is puncturing the tire of the power washer. After that, pull it out with an excellent yanking motion of your own arm. You should be able to take the puncturing item with no trouble.

Prepare the puncture for the plug

Have rubber cement and put approximately two or three drops of it to a rasp device and insert it directly into the tire puncture. Press it into the puncture in a rushed style and back out of the hole of the tire to get the hole cleaned and prepare it for the positioning of the tire plug.

Get ready the tire puncture plug strip

Grab the tire puncture plug strip and insert it into the eyelet of the hook instrument. Take the puncture plug strip farther through the eyelet of the needle device until the eyelet attains half of the whole strip.

Insert needle to the puncture hole in the tire

Grab the rubber cement again and place another two or three drops of it unto the end of the needle pool. Next, insert the needle instrument through the puncture hole of the power washer tire. Leave behind around ¼ of an inch of the material to protrude right above the top of the power washer tire.

Put the plug to the power washer tire

Twist the needle instrument handle ¼ turn and pull out the device from the tire. The plug needs to have remained right in the puncture hole of the tire. Trim down what is left behind of the tire plug material. This is so that there's just about 1/8 inch of the plug stuff that is protruding from the tire area.

Inflate the tire of the pressure washer

Determine the suggested pressure depending on PSI or pounds per square inch, by the supplier of the tires of the power washer system concerning the amount of air that the tire should have. You should also be able to locate this specific level of pressure along the side of the tire. Next, once you've determined this quantity, complete the tire with the appropriate pressure of air.

With just a little initiative and motivation for fixing small problems around the house, we could save a great deal of money in the long run.

Comments? Questions? Email Here

© HowtoAdvice.com

How to Advice .com