Remote Control Dip Switch Codes

Copyright (c) 2013 CeilingFanPartsOnline.com

Many followers now come with remote controls as an added convenience. When everything is working correctly, many people don't even consider how a remote control functions. However the minute that time-saver stops functioning properly, it is time to research the problem -- and immediately. Besides dead batteries (the most apparent reason for a non-working remote control), the most common cause of a faulty remote is related to the code resets, which are usually related to dip switch frequency problems.

Dip switches are the small switches located inside the physique of the remote and within the remote receiver, which is the part located within the ceiling fan itself. These switches seem like four small toggles, each of which sends out certain frequencies between the remote receiver and the remote control, which causes the enthusiast to respond. These frequencies are generally referred to as "codes."

All remote controls come with preset codes that allow the remote to communicate with the ceiling fan. Surprisingly, you can inadvertently reset this code, causing your remote to discontinue all communication with your fan. But all that's required in this situation is to simply reset the code. Unless you have the code written down somewhere or still have the manual (which is unlikely), you will likely need to open up your fan body to find the codes.

Depending on the specific fan model, the code could be found in any one of several different places. Generally, the code is created on the gold sticker within the fan housing. The simplest place to start the investigation for the code is by opening the light kit. The next logical places for the code to be are: on the top of the fan in the ceiling canopy, or near the top of the motor. You'll have to dismantle the enthusiast so be sure to shut down the electricity beforehand.

Once you find the right frequency for your remote, check that the dip switches in the remote and remote receiver in the fan are tuned to the same frequency. If they are tuned to exactly the same frequency, change both dip switches to another frequency to determine if that remedies the difficulty. Sometimes another wireless gadget in the home (such as a garage door opener remote) can interfere with your ceiling fan frequency if another device is about the same frequency.

Comments? Questions? Email Here

© HowtoAdvice.com